我買左支IBANEZ鋼線結他,都差不多大半年了,發覺按得都有點吃力,已換了弦,都好左少少,
請問有咩好解決方法?同埋我想問下TAYLOR這些大牌子,除了音色好之外,會否好按些?thank you

結他的手感，往往是要自己調節的，和結他價錢和牌子無太大關係。

一般想好按些，可調低弦距。
做法是可用六角匙調Trust Rod，去改變琴頸斜度，
另外也可用沙紙把Saddle磨低一點。
但注意，弦距過低會癡fret.

當然，可找熟結他朋友幫你調啦.
也可問問結他神醫Patrick幫你睇睇.

首先你支結他係咪調啱音呢?其次, 你可以量度吓第6絃第十二格位置同條fret既距離先(約3.5mm左右就最理想啦), 再度埋第6絃第一格同條fret既距離(約1-1.5mm), 超出以上距離就會好難按架喇, 另外, 絃既粗幼都有好大影响架. 最好可以影d相黎睇吓.

I have got a Farida R-16 recently. At first, I felt very difficult as the strings may be too hard for me. After 2 weeks trial, it's better. May be I got used to it. So, suggest to try longer and then take better action. I don't know if it's correct concept or not. If not, would Patrick please let me know.

BTW, the base is very very heavy with the pick-up on. How to do ?

Thanks for your comment.

Emma, yes, you will feel better when you get used to the tension of the strings and as the strength of your finger grow. But a roughly set guitar will ruin your effort in practiced and always giving you a hard time. I notice you are using a Classical guitar, it is different when you play a steel strings acoustic guitar. BTY, your R-16 is fitted with a set of .012 strings you may try a set of 0.11 strings next time you change them.
The bass is very heavy with the pickup on?
you mean the bass is too loud or it hums(feedback or with noise), have to try it for the reason, what type of Amp you are using?

hello~我聽左你地講之後,度了一下,嘩!原來我支結他(第6絃第十二格位置)的距離有(0.5mm)高呀!!而(第一格就3.5mm),咁我可以點做呀?結他絃我已用了(ELIXIR)0.11的.OK嗎?如果影相應該影那部份呢?唔該咁多位

Dear Patrick,

Thanks a lot. I will change the strings later. As a fact, the sound of this new guitar is very nice. Thanks for your fine tuning.

For the pick up, the bass was humming when it was plugged in my daughter's school's amp. Again, this happened when I used the amp in the folk song contest on Nov 17 (匯知). I don't know what amps they are. I will try again in Dec's house party in CW so Tong can help
me to verify the problem. Then, I can tell you.

Anyway, Thanks a lot for your help.

BTW, today is your Birthday. Wish you all the best !!!

Bottom's up but don't get drunk !!!



Emma

Thanks, EMMA.

引文:

弦距太高喇. 除非你想練大力金鋼指.
不過，我聽講過有d大師，係刻意調高個弦距，等d聲音出d，圓潤d，但相對難按一點。

你可以參考我上面講過o既方法調一調。

引文:
真係太高喇, 線就OK, 影相就影第一格同十二格既側面(有格數點嗰面), 自己磨SADDLE唔難, 鬆咗D絃, 將條SADDLE攞出黎, 用一張80號沙紙放平响枱面(雲石面仲好, 實夠平面)慢慢磨條saddle底部(即平面嗰度), 注意要第十二格度降低1.5mm, 條saddle就要磨兩倍高度, 大約3mm喇, 你可以逐少咁磨同埋要度好再响saddle度畫條線, 咁就清楚磨咗幾多啦. 都好好玩架. nut就比較難攪, 要有專用工具, 亂攪好易報癈架.